The 626mm 415V 2000W Halogen Heat Lamp: Packing Serious Heat Into a Small Space
We built this halogen heat lamp for the machines that need a serious blast of infrared heat, but don’t have room to spare. It’s the kind of component you install when you need more power in the same footprint as a standard shortwave quartz heater.
Power, Voltage, and Size—Why It All Matters
At 2000W and 415V, this lamp pulls serious power from a three-phase supply. The payoff? The current on each leg stays lower than it would with a 230V version. That means you can use smaller wiring and put less stress on your contactors. And the 626mm length? It gives you a precise heating zone—long enough to cover the exact area you need, but short enough to squeeze into tight spots inside a machine. It’s fast. Really fast. The lamp hits full output quickly, so your cycles keep moving and your timing stays steady.
Built to Handle the Grind
Inside, the halogen cycle does the heavy lifting. It keeps the filament stable by sending evaporated tungsten right back where it belongs. The result is consistent output over the life of the lamp, and less blackening on the tube. The quartz envelope is tough enough to take the jolt of rapid on/off cycling without cracking under thermal shock. And the R7s double-ended connector? It locks in clean and holds the lamp in proper alignment. If you’re already using R7s-fitted heaters, this is a straightforward drop-in replacement.
Where It Shines (And What to Watch For)
This setup is a common choice for plastics work—PET blowing, thermoforming, sealing—where you need intense heat in a small window. The high-voltage design keeps amp draw down, which is a real help. But it also means your control gear and insulation have to be rated for 415V. And because the output is intense, plan your heat shielding and ventilation. Nearby parts can bake if they’re not protected.